Updates from build discussions on dozens of 4x4 forums.
12:39 am on Apr 4th, 2017 EDT - updated by drewp
1942 Jeep Willys Build on Pirate4x4.com (more Jeep Willys builds)
donor axle and the tacoma center chunk got the knuckle balls removed on sunday i decided to take the...Click for drewp's full post
12:36 am on Apr 4th, 2017 EDT - updated by DanKunz
2003 Lexus GX 470 Build on IH8Mud.com (more Lexus GX builds)
I do. Out west but will update a bit more when I get back. Here are current...Click for DanKunz's full post
12:33 am on Apr 4th, 2017 EDT - updated by R.J.
1990 Ford Bronco II Build on ExplorerForum.com (more Ford Bronco II builds)
It's a bit messy because I didn't cut off any of th old brackets. welded the tubes to the center sec...Click for R.J.'s full post
11:45 pm on Apr 3rd, 2017 EDT - updated by 00TJTweety
Jeep Wrangler TJ Build on JeepForum.com (more Jeep Wrangler builds)
It has been awhile since i updated this and the jeep is still unfortunately in pieces...However i ha...Click for 00TJTweety's full post
11:33 pm on Apr 3rd, 2017 EDT - updated by dark_fairytales
1987 Toyota Truck Build on YotaTech.com (more Toyota Truck builds)
Completely clean and bare block all ready for it's adventure at the machine shop...Click for dark_fairytales's full post
11:26 pm on Apr 3rd, 2017 EDT - updated by frontierfreak7
Nissan Truck SE Build on ClubFrontier.org (more Nissan Truck builds)
...Click for frontierfreak7's full post
11:13 pm on Apr 3rd, 2017 EDT - updated by cruiser guy
Toyota Land Cruiser Diesel Conversion Build on IH8Mud.com (more Toyota Land Cruiser builds)
Got the right spring rates in and sitting on its own weight! Limit straps are on. New tie rod on and...Click for cruiser guy's full post
11:04 pm on Apr 3rd, 2017 EDT - updated by Halogrinder
1976 Ford F-Series Cheap Truck Challenge Build on Pirate4x4.com (more Ford F-Series builds)
Got a flange. Found a donut gasket. Got that cut off, welded on and NO LEAKS (on the drivers side).....Click for Halogrinder's full post
10:26 pm on Apr 3rd, 2017 EDT - updated by Bussy
1971 International Harvester Scout 800B Jello Shot Build on BinderPlanet.com (more International Harvester Scout builds)
TC decals on. One more part to finish. Thanks to Mike Moore and Jennifer for her decal installation...Click for Bussy's full post
10:22 pm on Apr 3rd, 2017 EDT - updated by habanero
1996 Toyota 4Runner Build on YotaTech.com (more Toyota 4Runner builds)
Schley #97300 timing belt tensioner compression tool. Only needed if you aren't replacing the hydrau...Click for habanero's full post
Go to page: